How To Swap Camera On Original Mavic Pro

Introduction

Follow this guide to remove the gimbal/camera of the DJI Mavic Pro M1P. Yous will need to remove the battery and upper shell before accessing the gimbal. Before attempting, exist aware that you will need to scrape off some plastic agglutinative that covers a couple screws. Tweezers and three different sized screwdrivers are required to access the gimbal/camera for this guide, every bit described below in the tools section.

• Grab both sides of the bombardment.

• Compression the releasing buttons on both sides of the battery.

• Lift the battery up and out.



• Remove the half dozen 5mm 1.v Hex screws by turning the screwdriver counterclockwise.

• Flip the drone over so that the gimbal is facing upwards.

• Remove the ii 4mm 1.five Hex screws well-nigh the gimbal case past turning the screwdriver counterclockwise.

• Remove the two 5mm 1.5 Hex screws near the gimbal case by turning the screwdriver counterclockwise.

• Remove the two pocket-sized panel pieces near the gimbal case with the tweezers.

• Remove the six 5mm 1.five Hex screws that are under the panel pieces by turning the screwdriver counterclockwise.

• Flip the drone back over so the upper vanquish is facing up.

• Pry off the upper shell with a nylon spudger.

• Be careful when prying with the spudger because you could damage the upper shell'due south plastic tabs.

• Remove the white connector at the back of the flight controller board by gently pulling at the base.

• Remove the 1 5mm JIS #0 spiral from the small micro controller lath at the front of the DJI Mavic Pro by turning counterclockwise.

• Pull the string and micro controller lath away from the front of the DJI Mavic Pro using tweezers.

• Expose the two small ZIF connectors most the front of the board past removing the plastic coverings.

• Then, remove the 2 ZIF connectors under the coverings using a nylon spudger.

• Remove two 6mm JIS #00 screws from the plastic board encompass at the front of the DJI Mavic Pro.

• Flip the DJI Mavic Pro over.

• Gently press the latch for the Gimbal encompass.

• Pull the cover off.

• Flip the DJI Mavic Pro back over, with its peak side facing up.

• Remove the two ZIF connectors located behind the plastic covers past using a nylon spudger.

• Gently remove the power cable connector located to the left, behind the gimbal board, by pulling up on the white base.

• Scrape away the plastic agglutinative covering the two 5mm JIS #000 screws connected to the gimbal lath.

• Remove the two 5mm JIS #000 screws from the gimbal lath by turning the screwdriver counterclockwise.

• Remove the ii 7mm JIS #00 screws at the very front of the DJI Mavic Pro by turning the screwdriver counterclockwise.

• Careful when removing these screws the photographic camera or whatsoever remains of your camera assembly may drib

• Flip the DJI Mavic Pro over, with the photographic camera facing you.

• Gently pull the gimbal/camera assembly upward and out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Squad

Embed this guide

Choose a size and re-create the code below to embed this guide as a small widget on your site / forum.

Preview

Source: https://www.ifixit.com/Guide/DJI+Mavic+Pro+Gimbal-Camera+Replacement/114214

Posted by: reedontomprods.blogspot.com

Share this post